Hide See September community winners
Community Awards
Celebrating our community
Amazing people. Inspiring projects. A stronger Domechy, together.
September 2026
Monthly Challenge WinnerFinal judge selection
inhaf@inhaf Selected as the September Monthly Challenge winner after the Top 5 public-vote finalists were reviewed in the final judging round.
Sponsored by
Top 4 Active MembersHighest September reward points
1
mfirdausk94
@mfirdausk94gmailcom
366pts
2
inhaf
@inhaf
332pts
3
ENCIK WAN
@terasemastrader
271pts
4
Amzar Aiman
@amzaraiman
241pts
mfirdausk94
@mfirdausk94gmailcom
366pts
2
inhaf
@inhaf
332pts
3
ENCIK WAN
@terasemastrader
271pts
4
Amzar Aiman
@amzaraiman
241pts
The four highest eligible member scores in Domechy Rewards for September.
Sponsored by
HariMau3D
HariMau3DProject of the MonthDomechy selection
ENCIK WAN@terasemastrader Mesin Filament dari Botol PET Kitar Semula
Selected as an outstanding community project this month.
Sponsored by
34 questions
asked by the Domechy community
Page 2 of 4
filament Tpu xboleh pakai ams ke
Anyone using this tool? Accurate x bacaan dia ni?
First time print lagi besar dri printer dan kene join the parts, any tips nak sambungkan dengan kemas dan kuat?
Betul ke nak print ASA suhu kena setup manual? atau memadai bermula dengan default?
Knapa ya kd2 dia poop merata
macam mana eh nak remove support dengan senang? I print pakai petg
Ada cara lain ke selain kena colour manual?
Ada siapa pernah pakai ni? Mcm mana nk pakai? Just apply smua plate?
Looking for advice on doing 1:64 diorama 🫡
Ni saya set ironing seperti gambar disebelah. Dan line width top surface 0.35.. tapi lubang kecil tu kenapa ya..
